Sprouts not only taste good, but they are also a great source of vitamins, fiber, protein, anti-oxidants, and enzymes. A sprout is produced when a seed starts growing into a vegetable. Sprouts can grow from the seeds of vegetables, from grains such as buckwheat, and from beans. While Mung beans are perhaps the most common source of sprouts, you can also obtain good results from lentils, soybeans and chickpeas just to name a few.

Sprouts can be grown almost anywhere and the best part is you only need a few basic supplies to get started. By following a few simple steps, you can receive a continual supply of nutritious sprouts.

While there are several commercial products available to cultivate sprouts, here are three of the easiest methods to help you get started.

- Growing Sprouts in Flower Pots -

1. Start with a clean clay or plastic flower pot. Make sure there is a hole in the bottom of the pot to ensure good drainage. Then place a piece of cheesecloth or muslin in the bottom of the pot over the hole so that the seeds/beans cannot fall out.

2. Next, soak the seeds or beans overnight and then put them in the pot. Remove any that are broken or damaged. Cover the plant pot with a dish.

3. Once a day, hold the pot under running water for a few minutes. This is to soak the seeds/beans thoroughly.

4. Once the sprouts begin to show, remove the dish and cover the pot with a piece of clear plastic wrap to let in the light. Place the sprouting pot near a window that allows daylight but is not in direct sunlight.

- Growing the Sprouts in Trays -

1. Soak the seeds or beans overnight. Remove any that are broken or damaged before you begin the sprouting process.

2. Select a low, flat dish (like a pie plate) or tray. You can purchase growing trays wherever planting supplies are sold.

3. Next, spread out a 2-inch layer of soil and then sprinkle the soaked seeds or beans on top of the soil.

4. Cover the seeds/beans with four layers of damp newspaper.

5. Cover the top of the tray with clear plastic wrap.

6. When the sprouts start to lift the plastic cover, (usually about three days) remove the newspaper.

7. Place the tray in a window so that the light can turn the sprouts green. You will need a space to place the sprouting tray that receives daylight but is not in direct sunlight.

8. Because the thin layer of soil dries out quickly, water twice each day.

9. After about 8-10 days, you will have sprouts tall enough to harvest.

- Growing Sprouts in a Jar -

1. Soak the seeds, grains, or beans in lukewarm water overnight in a wide-mouth glass jar. Remove any that are broken or damaged before you begin the sprouting process. (Sprouting increases the seed volume. 4- tablespoons will be sufficient for a quart size container.)

2. In the morning, pour off the water in the jar and rinse the seeds/beans thoroughly.

3. Place a piece of cheesecloth or muslin over the mouth of the jar. Use a rubber band to hold the material securely in place. This makes rinsing easier.

4. To keep the sprouts constantly damp, repeat the rinsing 2-3 times a day. Remember to drain any excess water because the sprouts should not stand in water.

5. Keep the jar away from the light for the first few days.

6. When the seeds/beans begin to sprout, (usually about the forth day) move the jar into the light to activate the chlorophyll and turn the sprouts green.

- Harvesting and Storing the Sprouts -

Newly germinated grain, seed, and sprouts, increase in food value in the very first period of growth.

Grains should be harvested and eaten from when they are six days old until they are 4-5 inches tall.

To harvest, just take your kitchen scissors and cut what you need.

Sprouts from beans, peas, etc., are ready earlier and can be eaten when they are 3-6 days old, depending on the type of sprout. For spouts grown in no soil or in seed trays, you can harvest the green "grass" when it starts to grow. Sprouts, from grain sown in jars, are ready sooner and are edible even before they turn green. Seeds sown in soil take a little longer.

If necessary, wash the sprouts thoroughly to remove the seed coat. Sprouts need to be stored in the refrigerator once they are ready to eat. Put the sprouts in tight sealing bags, and they will remain flavorful and crisp for one to two weeks. Rinsing the sprouts daily under cold water can extend their life.

Sprouts may be frozen by blanching them over steam for three minutes and then cooling them in ice water. Drain them and pack into freezer containers.

- Some of the Kinds of Seeds/Beans You Can Sprout -

The following list gives some of the popularly sprouted seeds/beans. It is not all inclusive as you can sprout almost any kind of seed. Remember that seeds soak up 2-3 times their dry volume in water and sprouts need at least six times the volume occupied by the seeds. So be sure that your container is large enough, and start with a minimal amount of seed in a container like a jar, until you determine the correct quantity that will grow to the sprout size you like, without being difficult to remove.

Your local garden shop or health food store will carry a line of seeds for sprouting. When purchasing seeds for sprouting, be certain that the seeds are intended for food and not for planting. This precaution is necessary because some seeds meant for planting have been treated with fungicides or insecticides to protect the young seedlings when planted in a field or garden.

Alfalfa - should be soaked for 6-12 hours. The seeds can be planted in the pots or jars and also in the flats with soil. 1-part seed gives 10-parts sprouts in approximately 5-6 days. Sprouts can be eaten after 3 days. When the root is 1-2 inches long, it will begin to develop tiny green leaves. At this stage, it needs to be eaten immediately so the plant will not switch to photosynthesis that exhausts the stored food in the seed.

Peas - when soaked in a glass jar, will grow sprouts in about 3 days. When the roots are 2-inches long, they are ready to eat. 1-part peas gives 2-parts sprouts.

Lentils - can be grown in either a glass jar or a plant pot and need to be soaked for 12-hours. The sprouts are ready in 3-4 days. Lentil sprouts are ready to be eaten when the root is 1-inch long. 1-part lentils gives 6-parts sprouts.

Barley, Oats, and Rye - should be soaked for 12-hours and then can either be grown as "grass" to harvest, or sprouts ready to eat after 3-4 days. The ideal length for eating is about 1/2-inch. 1-part seed gives 2-parts sprouts.

Soybeans - can be grown in a glass jar or a pot. They need to be soaked for 12-hours and sprouts are usually ready after 3-5 days. They are ready to eat when the root is 2-inches long. 1-part beans gives 4-parts sprouts.

Mung Beans - after soaking for 12-hours, these beans can be grown by any method. Mung beans are the most commonly grown sprouts and are usually ready to eat after 3-5 days. When the bright, white root grows from 1-2 inches long, they are ready to eat. 1-part beans gives 4-parts sprouts.

By growing your own sprouts, you will save yourself money because it is less expensive to buy sprout seeds and grow and harvest the sprouts yourself, than it is to buy the sprouts from a market.

Sprouting at home takes only a few minutes a day, and can produce a good part of your daily requirements of the nutrients you need from fresh produce. The hassles are minor, the costs are low, and the freshness is wonderful.

It's seed sprouting time for gardeners around the country getting ready for a new gardening season. Getting seeds started early and growing them into strong plants before the last frost gives you a headstart on enjoying summer fruits, vegetables and flowers.

Here's a great way to get a head start without using any toxic or dangerous chemicals... for a healthy garden and a healthy lifestyle for you and your plants. Whether you're starting tomatoes, peas or your favorite flowers, you can speed up the sprouting process and protect your seedlings from mildews and molds with simple hydrogen peroxide.

For wet sprouting (when using a flat surface and wet paper towel or other cloth) simply spray the outer surface of the damp material enclosing the seeds with a 3 percent hydrogen peroxide solution once a day after remoistening the sprouting seeds.

If you're using seed starter peat pots or other soil-based sprouting media, add 1/4 volume of 3 percent hydrogen peroxide to the water before watering the sprouts.

Using hydrogen peroxide in the watering and sprouting material will eliminate fuzzy molds and bacteria which often attack sprouting seeds. It will also speed up the sprouting process sometimes by as much as half.

If your sprouting seeds already have a fuzzy mold or growth don't despair, instead rinse the sprouts in a 3 percent solution of hydrogen peroxide and then reset in clean sprouting media. Before returning the sprouts to the tray or sprouting container wash it thoroughly with hot soapy water and then dry.

Which ever method you prefer to use, you'll have stronger healthier and more successful sprouting results when you supplement your watering with hydrogen peroxide. Don't forget to support those transplants when you move them into the garden later on in the season as well.

Continue to supplement watering with hydrogen peroxide even after the sprouts are up and beginning to grow. You can also use a straight 3 percent hydrogen peroxide solution to spray foliage, bark and blooms if you notice any kind of bacterial attack on your plants.